ACME’S KOOL-CEL
EVAPORATIVE COOLING PAD SYSTEM
Kool-Cel Pads

Designed with exclusive cross-fluted configuration which induces highly turbulent mixing inside the pad between water and air, and contributes to evaporative efficiency. The cross-fluted design makes Kool-Cel a strong self-supporting pad with high evaporative efficiency and low pressure drop (resistance to air flow).
These Evaporative Cooling Pad System is made specifically for hostile environments like green houses, poultry houses, dairy farms and the swine industry. Vitality evaporative media meets efficiency standards and exceeds pressure drop requirements. Kool-Cel media not only lasts longer, but helps keep your whole cooling system running longer by adding less stress to moving components.
A face velocity of 250 feet per minute for 4″ and 400 feet per minute for 6″ is recommended for the most economical cost.
Sizing Kool-Cel Pad

4″ KOOL-CEL PAD
The 4″ Kool-Cel pad is constructed with air flow at equal 45° angles which allows air flow to enter from either side of the pad.
6″ CELDEK PAD
The 6″ Celdek pad contains flutes organized in two angles, one with steep pitch and the other less pitched. The air must enter the pad from the side with the steep pitch.
MI-T-Edg ®
Optional coating on one or both sides of the pads reduces algae growth and enables easy pad cleaning and maintenance.
Following information is available with order upon request:
- Maintenance Guide
- Approved products and chemicals for use with pads
- Edge Coating Treatment
- Mineral Buildup Prevention Guide
- Particulate Removal Capabilities

4″ KOOL-CEL PAD
6″ CELDEK PAD